VixSkin Colossus

This penis extender is designed to be worn OVER penis. Colossus is large and very elastic in order to accommodate a range of penis sizes. The exterior features a pronounced veiny texture and coronal ridge, and the interior is circled with gentle ridges to grip the skin of the penis and keep the Colossus from slipping and sliding.

We think the Colossus is easiest to use over an erect penis, although depending on how it fits your body and how you intend to use it, it may also be usable without an erection. 

Note: Be sure to check the measurements carefully. The "Inner Sleeve" size listed below is for the WEARER. The "Outer Dildo Size" listed below is the size for the RECEIVER.

This sleeve will fit many/most penis sizes in an erect state, but not all. 

Note: Getting this sleeve on securely takes a few practice sessions to figure out. See "How best to to put on the Colossus" directions and suggestions below. 

SPECIFICATIONS

• Inner Sleeve Size: 
  • Length: 5 in
  • Inner Diameter: 1.3 in

• Outer Dildo Size:
  •  Overall Length: 9 in
  •  Insertable Length: 6.5 in
  •  Diameter: 2.16 in
    
    
• Material: Silicone
• Manufacturer: Vixen Creations
• Country of Origin: USA

ATTRIBUTES

• Soap & water or dishwasher to clean
• To sanitize boil for 3 minutes, OR
• To sanitize use alcohol or dilute bleach solution
• Waterproof
• Body-Safe
• Hypoallergenic
• Not compatible with silicone-based lube

How to best put on the Colossus:

The basic philosophy is to create a vacuum and pull the penis into the Ride On rather than to push. This is best accomplished by rolling the sleeve inside out about one third the way down the shaft. You will see a gripping ridge designed to help stability.

Use approximately a quarter's diameter size amount of water-based lubricant divided between the inside of the Ride On and your penis. Too much lubricant will eliminate the friction that helps your penis and the Ride On move as one. We recommend you practice putting it on at least once, before trying with a partner. This will allow you to fine tune the procedure.

With one hand squeeze the Ride On, eliminating the air inside. With your other hand, push the head of the penis into the opening and slowly release the pressure on the Ride On from the bottom up. This is accomplished by releasing the pinkie, then ring finger, middle finger then pointer. The action will pull your penis into place. Unroll the sleeve to the base of your body.

Pull your scrotum through the ring as far as possible. Then pull the ring with your left hand to the left and push through that testicle. Repeat on the other side. Both balls and the scrotum will be hanging through the ring for a secure fit. 

If your penis is not firmly held when using, reduce the amount of lubricant on the inside. Once you start to use the Ride On with a partner, use plenty of lube on the outside. This will make it more comfortable for your partner and also reduce the chance of internal slippage of your penis.